Renault Clio: Rear inner sill upper trim: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Trim And Upholstery / Body Internal Trim / Rear inner sill upper trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the complete rear bench seat.
- Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the trim at (2) and at (3).
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the rear door sill upper trim.
II - FINAL OPERATION
- Refit the seal (4).
- Refit the rear bench seat.
READ NEXT:
C-pillar upper trim: Removal - Refitting
C85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32),
the rear roof drip moulding lini
Quarter panel trim: Removal - Refitting
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see Airbag and pretensioners: Precautions
for the repair) (88C, Airbags and pretensio
Rear panel lining: Removal - Refitting
C85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Remove:
the front seat belt support bolt (1).
the front seat belt support.
Unclip:
the re
SEE MORE:
Oil level sensor: Removal -
Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Move the air inlet hose to one side.
Disconnect the connector from the oil level sensor.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Rem
Exhaust fuel injector cooler: Removal - Refitting
K9K, and 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Apply the discharge procedure for the exhaust injector fuel supply
system (see 19B, Exhaust, Exhaust fuel injector: Removal - Refit
© 2016-2025 Copyright Renault Clio Owners Club
