Renault Clio: Tyre pressure: Identification
Renault Clio III (2005-2013) Service Manual / Chassis / Wheels And Tyres / Tyre pressure: Identification
I - INFLATION
WARNING
If checking the tyre pressure when hot, increase the recommended pressure by 0.2 to 0.3 bar.
B85 or C85 or S85
The pressure values given are recommendations when cold.
K85
II - CONFORMITY CHECK AND ADJUSTMENT
If the tyre size is changed, calibrate the electric power-assisted steering computer using the Diagnostic tool (see MR 394 Fault finding, 36B, Electric power-assisted steering, Replacement of components).
Wheel rim offset:
- steel wheel rim: 43 mm,
- alloy wheel rims: 50 mm.
For information on fitting chains, see " Driver's handbook ".
Tyres: Identification
Example of a tyre identification mark: 205/65 R 15 91 V.
Speed code table:
READ NEXT:
Wheel rim: Identification
IDENTIFICATION
1 - Marking
There are two types of identification marking on the
wheel rims:
engraved marking for steel wheel rims,
cast marking for alloy wheel rims.
The marking gives the main dim
Tyre Pressure Monitor
Tyre pressure monitor: List and location of components
TYRE PRESSURE SENSOR
The system consists of:
four pressure sensors (1) built into the valves (one per
wheel); the sensors transmit a radio si
SEE MORE:
Side decorative strips: Removal - Refitting
Note:
Once removed, the side decorative strips cannot
be refitted and must be replaced each time.
REMOVAL
I - REMOVAL PREPARATION OPERATION
1 - Front side door
Remove:
the front side door trim (see Front side door trim:
Removal - Refitting) (72A, Side opening element
trim),
the door mirror
Sill panel extension: Removal - Refitting
EQUIPMENT LEVEL EAC or EQUIPMENT LEVEL SPORT
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the bolts (1).
Detach the decorative strip (2).
Note:
Replace the decorative strip (2) every time it is
removed.
Remove the bolts (3).
Detach the double-sided tape (4) using the (Car.1
© 2016-2026 Copyright Renault Clio Owners Club - 0.0034
