Renault Clio: B-pillar trim: Removal - Refitting
B85

REMOVAL
I - REMOVAL PREPARATION OPERATION

- Move the seats fully forward.
- Partially remove the frame seals (1).
- Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCERNED

- Unclip the B-pillar lower trim at (2).

- Remove the B-pillar lower trim.

- Unclip bolt cover.
- Remove the bolt (3).

- Use a flat-blade screwdriver to unclip the height adjustment control
(4).

- Unclip (5) the B-pillar upper trim (6).

REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Reclip:
- the B-pillar upper trim,
- the height adjustment device.
- Torque tighten the seat belt bolt (21 Nm).
- Reattach the B-pillar lower trim.
II - FINAL OPERATION.
- Refit the front and rear door sill trims.
- Refit the frame seals.
READ NEXT:
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
C85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32),
the rear roof drip moulding lini
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see Airbag and pretensioners: Precautions
for the repair) (88C, Airbags and pretensio
SEE MORE:
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note:
Ready-to-use coolant or antifreeze must be diluted
with distilled water in accordance with the guidelines
marked on the container.
Engine cooling: Precautions for the repair
IMPORTANT
The circuits are designed to be pressurized, so be
careful at high temp
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not open the expansion bottle cap,
do not drain the cooling system,
do not open the bleed screw(s).
N
© 2016-2026 Copyright Renault Clio Owners Club - 0.003
