Renault Clio: Cabin filter: Removal - Refitting
LEFT-HAND DRIVE
Note:
The cabin filter is located in the passenger side A-pillar.
REMOVAL
I - REMOVAL PREPARATION OPERATION
SCHOOL VEHICLE
- Remove the clutch pedal (see Clutch pedal: Removal
- Refitting) (MR392, 37A, Mechanical component
controls).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the passenger compartment filter at (1).
- Remove the cabin filter.
Note:
Foreign bodies (leaves, insects etc.) are likely to
accumulate in the cabin filter. Remove the cabin
filter with care so as to prevent foreign bodies
getting into the evaporator.
REFITTING
I - REFITTING PREPARATION OPERATION
- Check for foreign bodies in the passenger compartment
filter housing, and clean thoroughly if necessary.
II - REFITTING OPERATION FOR PART
CONCERNED
- Engage the upper section of the base of the filter into
the distribution unit.
- Clip the lower section of the filter base onto the distribution
unit.
III - FINAL OPERATION
SCHOOL VEHICLE
- Refit the clutch pedal (see Clutch pedal: Removal -
Refitting) (MR 392, 37A, Mechanical component
controls).
RIGHT-HAND DRIVE
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the passenger compartment filter at (1).
Note:
Foreign bodies (leaves, insects etc.) are likely to
accumulate in the passenger compartment filter.
Remove the filter with care so as to prevent foreign
bodies getting into the evaporator.
- Remove the passenger compartment filter.
REFITTING
I - REFITTING PREPARATION OPERATION
- Check for foreign bodies in the cabin filter housing,
and clean thoroughly if necessary.
II - REFITTING OPERATION FOR PART
CONCERNED

READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 394, 88C, Airbags and pretensioners).
Disconnect
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove seal (1).
Remove the side panel (2).
Remove the bolt (3) from the base
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the glovebox (see Glovebox: Removal - Refitting)
(MR 393, 57A, Interior equipment),
SEE MORE:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the door trim (see Front side door trim: Removal
- Refitting) (MR 393,72A, Side door trim),
the door lock barrel (see 51A, Side opening element
mechanisms, Front side door lock barrel:
Removal - Refitting, 51A-4).
Open the lock a
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 2
IMPORTANT
Before doing any work on a safety system component,
be sure to lock the airbag computer using the
Diagnostic tool (see Airbag and pretensioners:
Precautions for the repair). When this function is
activated, all the trigger lines are inhibited
© 2016-2025 Copyright Renault Clio Owners Club
