Renault Clio: Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
- Shift the selector lever to third gear.

- Fit a shim (1) (6 mm between the locking ring and
reverse gear interlock on the selector lever.
- Use a strap (2) to immobilise the lever against the
shim in third gear position.
2 - Engine compartment
- Position the gear lever on the gearbox in "third gear
engaged" position.

- Unlock the selector cable adjustment clip by compressing
the lock ring (3) and push the orange clip
(4) upwards
(1).
- Adjust the length of the cable accordingly and fit it
onto the gear selection lever ball joint.

- Lock the cable by pressing on the orange clip (5).
- Check that gear selection is correct.
READ NEXT:
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PRE
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
SEE MORE:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
K9K, and 750
Undo the clip (1) from the intercooler outlet pipe.
Move the intercooler outlet air pipe to one side (2).
Remove the turbocharger outlet air pipe reta
Door mirrors with electrical adjustment
With the ignition on, turn button 1:
position C to adjust the left-hand
door mirror;
position E to adjust the right-hand
door mirror;
D is the inactive position.
For safety reasons, carry
out any adjustments when
the vehicle is
© 2016-2025 Copyright Renault Clio Owners Club
