Renault Clio: Tools
The tools included in the tool kit depend on the vehicle.
Tool kit A is located in the tray under the luggage compartment carpet.
Lift the cover and remove it.
Wheelbrace 1
Locks or unlocks the wheel bolts and tow eye 5
Jack 2
Fold it correctly before refitting it in its housing (ensure that the wheelbrace is correctly positioned).
Hubcap tool 3
This tool is used to remove the wheel trims.
Wheel bolt guide 4
To finish loosening or starting to tighten the wheel bolts.
Tow eye 5
Please see “Towing: breakdown recovery” in Section 5.
Lever 6
This tightens or releases the tow eye 5.
| Do not leave the tools unsecured inside the vehicle as they may come
loose under braking. After use, check that all the
tools are correctly clipped into the tool kit, then position it
correctly in its housing: there is a risk of injury. If wheel bolts are supplied in the tool kit, only use these bolts for the emergency spare wheel: refer to the label affixed to the emergency spare wheel. The jack is designed for wheel changing purposes only. Under no circumstances should it be used for carrying out repairs underneath the vehicle or to gain access to the underside of the vehicle. |
READ NEXT:
Wheel trims - wheel
Remove the wheel trim using hubcap
tool 1 (located in the tool kit) by engaging
the hook in the opening near
valve 2.
To refit it, align it with valve 2. Push the
retaining hooks in fully,
Changing a wheel
Switch on the hazard warning
lights.
Keep the vehicle away from
traffic and on a level surface
where it will not slip.
Apply the parking brake and engage
a gear (first or
Tyres (tyre and wheel safety, use in winter)
Tyre and wheel safety
The tyres are the only contact between
the vehicle and the road, so it is essential
to keep them in good condition. You
must comply with the local rules given
in the highway
SEE MORE:
Air flowmeter: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Loosen the clip (1) between the air duct and the air
flowmeter.
Disconnect the air flowmeter connector.
Unfasten the air duct and remove it.
Disconnect the air flowmeter connector.
II
Front left-hand wiring: Connector access
I - LOCATION OF CONNECTORS
Connection R 107 (front left-hand wiring/dashboard
wiring connection) composed of two to four connectors
depending on equipment.
R 374 connector (front left-hand wiring/rear left-hand
wiring connection).
Connection R 67 (front left-hand wiring/engine wiring
