Renault Clio: Audible and visual signals
Renault Clio IV (2014-2019) Owners Manual / Getting to know your vehicle / Audible and visual signals
Horn
Press steering wheel boss A.
Headlight flasher
Pull stalk 1 towards you to flash the headlights.
Direction indicators
Move stalk 1 parallel to the steering wheel and in the direction you are going to turn it.
One-touch mode
When driving, it is possible that the steering wheel may not be turned sufficiently to return the stalk automatically to its starting position.
In this case, move the stick 1 to halfway, then release it: the stalk returns to its original point and the indicator light flashes three times
Hazard warning lights
Press switch 2.
This switch activates all four direction indicators and the side indicator lights simultaneously. It must only be used in an emergency to warn drivers of other vehicles that you have had to stop in an area where stopping is prohibited or unexpected, or that you are obliged to drive under special conditions.
Depending on the vehicle, the hazard warning lights may come on automatically under heavy deceleration.
You can switch them off by pressing switch 2 once.
READ NEXT:
Headlight adjustment
On vehicles fitted with this function,
control A allows you to adjust the height
of the beams according to the load.
Turn control A downwards to lower the
headlights and upwards to raise the
Windscreen washers and wipers
With the ignition on, move stalk 1
A park.
B intermittent wiping.
The wipers will pause for several
seconds between sweeps. It is
possible to change the time between
sweeps by turn
Rear screen wash/wipe
Speed-dependent
timed rear screen
wiper
With the ignition on, turn the end of
stalk 1 to align mark 2 with the symbol.
Wiping frequency varies with speed.
When working in the engin
SEE MORE:
Damper valve: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
Remove:
the air inlet duct (1),
the damper valve duct (2).
Remove:
the retaining bracket bolts (3),
the retaining bracket.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
Shift the selector lever to third gear.
Fit a shim (1) (6 mm between the locking ring and
reverse gear interlock on the selector lever.
Use a strap (2) to immobilise the lever against the
shim
