Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Multifunction switch: Removal - Refitting

DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Shift the selector lever to Neutral. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the battery tray (se

 Speed sensor: Removal - Refitting

DP0 Do not drain or remove the automatic gearbox in order to remove the speed sensor. The output speed sensor has been deleted and replaced with wheel speed sensors. REMOVAL I - REMOVAL PREPARATION

 Pressure sensor: Removal - Refitting

DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on the two-post lift (see 02A, Lifting equipment, Vehicle: Towing and lifting). Disconnect the battery (see 80A, Battery, Batter

SEE MORE:

 Charge circuit: Specifications

D4F or F4R or K4J or K4M or K9K or M4R ALTERNATOR SPECIFICATIONS Charge circuit: Function D4F or F4R or K4J or K4M or K9K or M4R OPERATION These vehicles are fitted with a built-in regulator and an instrument panel warning light which operates as follows: when the ignition is switched on, the war

 Dashboard: Removal - Refitting

IMPORTANT To avoid all risk of damage to the systems, apply the safety and cleanliness instructions and operation recommendations before carrying out any repair: (see Airbag and pretensioners: Precautions for the repair) (88C, Airbag and pretensioners), (see Vehicle: Precautions for the repair)

© 2016-2025 Copyright Renault Clio Owners Club