Renault Clio: Boot storage
Mobile floor
When fitted to the vehicle, it can be used to make loading easier.
Note: if you need to access the ISOFIX ring and/or the net ring at the bottom of the boot, open flap 3.
| Maximum weight for the mobile floor: 100 kg evenly distributed. |
Movable floor storage
- Lower section 1 onto section 2;
- lift the assembly and position it against the back of the rear bench seat;
- push the catch 4 to lock the mobile floor in the folded position.
Removing the mobile floor
- Lower section 1 onto section 2;
- remove the assembly.
Repositioning the mobile floor
Position it in the boot, using the 5 runners provided.
READ NEXT:
Transporting objects in the boot
Always position the objects transported
so that the largest surface is against:
The rear bench seatback for normal
loads (example A).
The front seatbacks with the rear
seatbacks
Towing, attachments
Permissible nose weight, maximum
permissible towing weight,
braked and unbraked: refer to
the information on “Weights” in
Section 6.
For fitting and conditions of use,
SEE MORE:
Structural components to be positioned on the repair bench: Description
I - PARTS REQUIRING THE USE OF A BODY JIG
BENCH
Radiator cross member support
Centre floor front side cross member
Front side member closure panel
Front side member
Engine stand
Front half-unit
Front wheel arch
Engine tie-rod attachment
Inner rear wheel arch
Rear side member
Rear sectio
Scuttle side panel: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associated
with the vehicle. These special notes are specified
i
© 2016-2025 Copyright Renault Clio Owners Club
