Renault Clio: Rear end panel lining: Removal - Refitting

REMOVAL
I - REMOVAL PREPARATION OPERATION
B85 or C85 or S85

- Remove the luggage compartment carpet.
K85

- Remove the luggage compartment raised floor (1).

- Remove the luggage compartment carpet (2).
- Partially remove the luggage compartment seal.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85 or S85

- Remove the clips (3) using a flat-blade screwdriver.

- Remove the towing ring bolts (4).

- Unclip the rear end panel trim.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the rear end panel lining,
- the towing rings.
- Torque tighten the towing ring bolts (21 Nm).
B85 or C85 or S85

II - FINAL OPERATION.
B85 or C85 or S85
- Refit the luggage compartment carpet.
K85
- Remove:
- the luggage compartment carpet (2),
- the luggage compartment raised floor (1).
- Refit the luggage compartment seal.
READ NEXT:
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear parcel shelf,
the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the clips (2).
Remove
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front speaker (see Front speakers:
Removal - Refitting) (MR 392, 86A, Radio).
Unclip the door mirror trim piece (1).
II - OPERATION FOR REM
SEE MORE:
DP0
Do not drain or remove the automatic gearbox in order
to remove the speed sensor.
The output speed sensor has been deleted and replaced
with wheel speed sensors.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A,
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydr
© 2016-2025 Copyright Renault Clio Owners Club
