Renault Clio: B-pillar upper trim: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Trim And Upholstery / Body Internal Trim / B-pillar upper trim: Removal - Refitting
C85
REMOVAL
REMOVAL PREPARATION OPERATION
- Remove:
- the complete rear bench seat,
- the rear wing panel lining (see 71A, Body internal trim, Rear panel lining: Removal - Refitting, 71A-32).
- Remove:
- the bolt (1),
- the seat belt.
- Unclip the height adjustment device (2).
- Remove the covers (3).
- Unclip the trim at (4).
- Remove the B-pillar upper trim.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the B-pillar upper trim.
- Refit the covers (5).
II - FINAL OPERATION
- Refit the height adjustment device (6).
- Refit the seat belt.
- Tighten to torque the seat belt mounting bolt (21 Nm). (7)
- Refit:
- the rear wing panel lining (see 71A, Body internal trim, Rear panel lining: Removal - Refitting, 71A-32),
- the complete rear bench seat.
READ NEXT:
B-pillar trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Move the seats fully forward.
Partially remove the frame seals (1).
Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCE
Rear inner sill upper trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
C-pillar upper trim: Removal - Refitting
C85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32),
the rear roof drip moulding lini
SEE MORE:
Automatic gearbox
Selector lever 1
P: park
R: reverse
N: Neutral
D: automatic mode
M: manual mode
+: upper gear
–: lower gear
4: displays the gear engaged in manual
mode.
Note: Press the button 2 to go from position
D or N to R or P.
Operation
With the selection lever 1 in position P,
switch o
Exhaust gas recirculation unit: Removal - Refitting
K9K, and 750 or 752
REMOVAL
Position the vehicle on a two-post lift.
Remove the scuttle panel grille (see Scuttle panel grille: Removal -
Refitting).
Disconnect the exhaust gas recirculation solenoid valve electrical
wiring harness (4).
Detach the electric wiring harness.
Disconnect
© 2016-2025 Copyright Renault Clio Owners Club
