Renault Clio: Heating: List and location of components
LEFT-HAND DRIVE
- Control panel
- Cabin filter
- Rear air distribution duct
- Recirculation control cable
- Air distribution cable
- Air mixing cable
- Air distribution unit
- Heater matrix
- Fan assembly
- Heating resistor relay
- Heating resistors:
- Blower control unit.
- Front side air distribution duct
- Front central air distribution duct
- A-pillar air distribution duct
- External temperature sensor
CLIMATE CONTROL
- Passenger compartment temperature sensor
- Solar radiation sensor





The evaporator is supplied already assembled in the
distribution unit. (7)





CLIMATE CONTROL

CLIMATE CONTROL
CLIMATE CONTROL
- Motor-driven fan assembly control unit
- Mixing motor
- Wiring harnesses
- Recirculation motor
- Distribution motor
- Fan assembly
- Cabin filter
- Heater matrix pipes
- Heater matrix
- Heater resistance
- Air distribution unit
- Heater matrix pipe mounting bracket

RIGHT-HAND DRIVE
- Control panel
- Cabin filter
- Rear air distribution duct
- Recirculation control cable
- Air distribution cable
- Air mixing cable
- Air distribution unit
- Heater matrix
- Fan assembly
- Heating resistor relay
- Heating resistors:
- Blower control unit.
- Front side air distribution duct
- Front central air distribution duct
- A-pillar air distribution duct
- External temperature sensor
CLIMATE CONTROL
- Passenger compartment temperature sensor
- Solar radiation sensor





The evaporator is supplied already assembled in the
distribution unit. (7)






CLIMATE CONTROL


CLIMATE CONTROL
CLIMATE CONTROL
- Motor-driven fan assembly control unit
- Mixing motor
- Wiring harnesses
- Recirculation motor
- Distribution motor
- Fan assembly
- Cabin filter
- Heater matrix pipes
- Heater matrix
- Heating resistors:
- Air distribution unit
- Heater matrix pipe mounting bracket

READ NEXT:
LEFT-HAND DRIVE
Note:
The cabin filter is located in the passenger side A-pillar.
REMOVAL
I - REMOVAL PREPARATION OPERATION
SCHOOL VEHICLE
Remove the clutch pedal (see Clutch pedal: Removal
- Refit
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 394, 88C, Airbags and pretensioners).
Disconnect
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove seal (1).
Remove the side panel (2).
Remove the bolt (3) from the base
SEE MORE:
D4F or F4R or K4J or K4M or K9K or M4R
ALTERNATOR SPECIFICATIONS
Charge circuit: Function
D4F or F4R or K4J or K4M or K9K or M4R
OPERATION
These vehicles are fitted with a built-in regulator and an
instrument panel warning light which operates as follows:
when the ignition is switched on, the war
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see 30A, General information, Brake circuit:
Precautions for the repair, 30A-2).
This procedure must be applied after one of the followin
© 2016-2025 Copyright Renault Clio Owners Club
