Renault Clio: Rear side door trim: Removal - Refitting
B85 or K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Special features of vehicles fitted with manual
window winders

- Unclip the winder handle (1) using a pair of unclipping
pliers (protect the door trim).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the trim piece and bolt (2).
- Take out interior handle.
- Disconnect the supply connectors (depending on
equipment level).

- Remove the trim piece and bolt (3).

- Remove the bolts (4).
- Remove trim using a pair of unclipping pliers (protect
the door box section).
- Unclip the interior door handle cable using a flat-blade
screwdriver.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Reclip:
- the interior door handle cable,
- the door trim.

- Refit:
- the bolts (5),
- the trim piece and bolt (6).

- Reconnect the supply connectors on the window
switch (depending on equipment level).
- Refit:
- the interior handle,
- the trim piece and bolt (7).
II - FINAL OPERATION.
Special features of vehicles fitted with manual
window winders
- Reclip the winder handle.
- Carry out a function test.
Non-side Opening Elements Trim
Tailgate trim: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the bolts (1).
- Unclip the tailgate side trim panels (2).

- Remove the bolts (3).
- Unclip the tailgate trim (4).
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- Clip the tailgate trim in place.
- Refit the bolts (3).
- Clip on the tailgate side trim panels.
- Refit the bolts (1).
READ NEXT:
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 2
IMPORTANT
Before beginning work on any component of the
safety system, it is essential to lock the airbag computer
using the Diagnostic tool (see Airbag
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 2
IMPORTANT
Before beginning work on any component of the
safety system, it is essential to lock the airbag computer
using the Diagnostic tool (see Airbag
SEE MORE:
JH3 or JR5
Note:
Each time an operation is carried out on the
hydraulic clutch system, bleed the circuit:
between the reservoir and the bleed hole,
between the bleed hole and the clutch release
bearing.
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M
Remove the resonator.
Remov
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note:
Ready-to-use coolant or antifreeze must be diluted
with distilled water in accordance with the guidelines
marked on the container.
Engine cooling: Precautions for the repair
IMPORTANT
The circuits are designed to be pressurized, so be
careful at high temp
© 2016-2025 Copyright Renault Clio Owners Club
