Renault Clio: Rubber bush: Adjustment
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rubber bush: Adjustment
WARNING
Never use the rear axle as support for a lifting system.
ADJUSTMENT
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Release the parking brake.
- Remove the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
- Unclip the speed sensor harness at (1).
- Loosen the rubber bush nuts (2).
- Remove the springs (see 33A, Rear axle components, Rear suspension spring: Removal - Refitting, 33A-27).
- Place the tool component jack in contact with a shim under the rear axle near the shock absorber at (3).
- Adjust the component jack in order to obtain a distance (X1) of 150 mm between the lower mounting of the shock absorber and the side member.
- Torque tighten the rubber bush bolt (105 N.m).
- Do the same for the other side.
- Refit the springs (see 33A, Rear axle components, Rear suspension spring: Removal - Refitting, 33A-27).
- Clip on the speed sensor harness.
- Refit the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
READ NEXT:
Rear brake pads: Removal - Refitting
16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and
ELECTRONIC STABILITY
PROGRAM
When replacing brake pads, be sure to replace the
pads on the opposite side.
WARNING
To avoid damag
Rear brake hose: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
Prepare for brake fluid outflow, to p
Rear brake calliper: Repair
WARNING
Prepare for the flow of fluid, and protect the surrounding
components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (
SEE MORE:
Side Opening Elements
Front side door: Removal - Refitting
I - REMOVAL WITHOUT HINGES
1 - REMOVAL PREPARATION OPERATION
Disconnect the door wiring harness supply connector.
2 - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the door mounting nuts (1),
the door.
II - REFITTING WITHOUT HINGES
1 - OPERATION
Air conditioning: Precautions for the repair
AIR CONDITIONING or CLIMATE CONTROL
I - SAFETY
IMPORTANT
The following must be worn when handling refrigerant:
gloves,
protective goggles (with side shields if possible).
In the event of refrigerant fluid coming into contact
with the eyes, rinse well with clean water continuously
for 15 minutes.
© 2016-2025 Copyright Renault Clio Owners Club
