Renault Clio: Tyre pressure: Identification
Renault Clio III (2005-2013) Service Manual / Chassis / Wheels And Tyres / Tyre pressure: Identification
I - INFLATION
WARNING
If checking the tyre pressure when hot, increase the recommended pressure by 0.2 to 0.3 bar.
B85 or C85 or S85
The pressure values given are recommendations when cold.
K85
II - CONFORMITY CHECK AND ADJUSTMENT
If the tyre size is changed, calibrate the electric power-assisted steering computer using the Diagnostic tool (see MR 394 Fault finding, 36B, Electric power-assisted steering, Replacement of components).
Wheel rim offset:
- steel wheel rim: 43 mm,
- alloy wheel rims: 50 mm.
For information on fitting chains, see " Driver's handbook ".
Tyres: Identification
Example of a tyre identification mark: 205/65 R 15 91 V.
Speed code table:
READ NEXT:
Wheel rim: Identification
IDENTIFICATION
1 - Marking
There are two types of identification marking on the
wheel rims:
engraved marking for steel wheel rims,
cast marking for alloy wheel rims.
The marking gives the main dim
Tyre Pressure Monitor
Tyre pressure monitor: List and location of components
TYRE PRESSURE SENSOR
The system consists of:
four pressure sensors (1) built into the valves (one per
wheel); the sensors transmit a radio si
SEE MORE:
Diesel filter: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the front right-hand wheel (see Wheel: Removal -
Refitting) (MR 392, 35A, Wheels and tyres),
the right-hand wheel arch liner (see Front wheel
arch liner: Removal - Refitting) (MR 393, 55A,
Exterior protection).
II - OPERATION FOR
Trip computer and warning system
Information messages
These can help in the vehicle starting phase, or give information about a
selection or a driving status.
Examples of information messages are given in the following pages.
Examples of messages
Interpreting the display selected
« PARKING BRAKE O
© 2016-2025 Copyright Renault Clio Owners Club
