Renault Clio: Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
- Shift the selector lever to third gear.

- Fit a shim (1) (6 mm between the locking ring and
reverse gear interlock on the selector lever.
- Use a strap (2) to immobilise the lever against the
shim in third gear position.
2 - Engine compartment
- Position the gear lever on the gearbox in "third gear
engaged" position.

- Unlock the selector cable adjustment clip by compressing
the lock ring (3) and push the orange clip
(4) upwards
(1).
- Adjust the length of the cable accordingly and fit it
onto the gear selection lever ball joint.

- Lock the cable by pressing on the orange clip (5).
- Check that gear selection is correct.
READ NEXT:
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PRE
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
SEE MORE:
Opening the doors from the outside
Front doors
With the doors unlocked, pull handle 1.
Special feature of the RENAULT
“hands-free” card
With the doors locked, press button 2
on handle 1 of one of the two front
doors and pull towards you.
Rear doors
With the doors unlocked, pull hand
Locking/Unlocking the doors
from the outside
This is done using the RENAULT Card;
see the “RENAULT Card” information in
Section 1.
In certain cases, the RENAULT card
may not work:
if the RENAULT card battery is weak,
flat, etc.
if equipment operating on the same
frequency as the ca
© 2016-2026 Copyright Renault Clio Owners Club - 0.0046
