Renault Clio: Engine oil grade

Refer to the Maintenance Service Booklet for your vehicle.

Filling: take care when topping up the oil that no oil drips onto engine components - risk of fire.

Remember to refit the cap securely as there is a risk of fire if oil splashes onto hot engine components.

When working in the engine compartment, ensure that the windscreen wiper stalk is in the park position.

Risk of injury

The engine may be hot when carrying out operations in close proximity. In addition, the engine cooling fan can come on at any moment.

Risk of injury.

Consult your approved dealer at once if you notice an abnormal or repeated drop in any of the fluid levels.

Exceeding the maximum engine oil level

Under no circumstances must the maximum fill level be exceeded: risk of damage to the engine and catalytic converter.

If the oil level exceeds the maximum level, do not start your vehicle and contact an approved Dealer.

Never run the engine in an enclosed space as exhaust gases are poisonous.

Engine oil change: if you are changing the oil when the engine is hot, be careful not to scald yourself if the oil overflows.

READ NEXT:

 Levels

 Engine coolant

With the engine switched off and on level ground, the level when cold must be between the MINI and MAXI marks on reservoir 1. Top this level up when cold before it reaches the MINI mark.

 Brake fluid

The level should be read with the engine switched off and on level ground. This should be checked frequently, and immediately if you notice even the slightest loss in braking efficiency.

SEE MORE:

 Five door and estate versions

Reversing lights and rear fog lights 12 Open the boot lid. Unclip cover 13 and remove it. Turn bulb holder 14 fully anticlockwise and change the bulb. To reassemble, proceed in the reverse order to removal. When the bulb has been changed, make sure you refit the cover 13 cor

 Sunroof opening control: Removal - Refitting

PANORAMIC SUNROOF REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Unclip the roof opening control using a flat-blade screwdriver (1). Disconnect the connectors. REFITTING REFITTING OPERATION FOR PART CONCERNED Connect the connectors. Clip the sunroof opening control. Sunroof operating mecha

© 2016-2025 Copyright Renault Clio Owners Club