Renault Clio: Pre-postheating unit: Removal - Refitting
K9K

REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the battery (see Battery: Removal - Refitting),
- the battery tray (see Battery tray: Removal - Refitting)
(MR 392, 80A, Battery).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the pre-postheating unit mounting bolt (8).

- Disconnect the pre-postheating unit connector (9).
- Remove the pre-postheating unit.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Connect the pre-postheating unit connector.
- Refit the pre-postheating unit.
- Tighten to torque the pre-postheating unit mounting
nut (9 Nm).
II - FINAL OPERATION.
- Refit the battery (see Battery: Removal - Refitting)
READ NEXT:
K9K, and 764 or 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter box inlet air pipe (1).
Remove the turbocharger outlet air pipe retaining pins (2).
Remove:
the turbochar
K9K
K9K, and 764 or 766 or 768 or 772
First fitting of the exhaust gas cooler recirculation
assembly
(1) Exhaust gas recirculation solenoid
valve
(2) Exhaust gas cooler
(3) Exhaust gas inlet pipe
(4)
SEE MORE:
B85 or C85
IMPORTANT
Consult the safety and cleanliness advice and
operation recommendations before carrying out
any repair (see Airbag and pretensioners: Precautions
for the repair) (88C, Airbags and pretensioners).
IMPORTANT
To avoid any risk of triggering when working on
or near a pyrotechnic co
LEFT-HAND DRIVE
Note:
The cabin filter is located in the passenger side A-pillar.
REMOVAL
I - REMOVAL PREPARATION OPERATION
SCHOOL VEHICLE
Remove the clutch pedal (see Clutch pedal: Removal
- Refitting) (MR392, 37A, Mechanical component
controls).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
© 2016-2025 Copyright Renault Clio Owners Club
