Renault Clio: To the rear seat belts

Force limiter

Above a certain severity of impact, this mechanism is used to limit the force of the belt against the body so that it is at an acceptable level.

  • Have the entire restraint system checked following an accident.
  • No operation whatsoever is permitted on any part of the system (air bags, electronic control units, wiring) and the system components must not be reused on any other vehicle, even if identical.
  • Only qualified personnel from our Network may work on the air bags; otherwise the system may trigger accidentally and cause injury.

READ NEXT:

 Side

Side Airbags This airbag may be fitted to each of the front seats and is activated at the sides of the seats (door side) to protect the occupants in the event of a severe side impact. Dep

 Additional methods of restraint

All of the warnings below are given so that the airbag is not obstructed in any way when it is inflated and also to prevent the risk of serious injuries caused by items which may be dislodged when

 Child safety

SEE MORE:

 Camshaft dephaser: Removal - Refitting

M4R The engine and gearbox assembly must be removed to remove/refit the camshaft dephaser (see 10A, Engine and cylinder block assembly, Engine - gearbox assembly: Removal - Refitting, 10A-112). For the camshaft dephaser removal-refitting procedure (see ) (Technical Note 6020A, 10A, Engine and

 Clutch circuit: Removal - Refitting

JH3 or JR5 Note: Each time an operation is carried out on the hydraulic clutch system, bleed the circuit: between the reservoir and the bleed hole, between the bleed hole and the clutch release bearing. REMOVAL I - REMOVAL PREPARATION OPERATION K4J or K4M Remove the resonator.   Remov

© 2016-2025 Copyright Renault Clio Owners Club