Renault Clio: Car Phone

Car phone: List and location of components

CAR PHONE PRE-EQUIPMENT or HANDS-FREE TELEPHONE KIT

I - LIST OF COMPONENTS

The " car phone " consists of:

• a telephone aerial
• a computer
• a "hands-free" microphone
• a telephone control on the steering wheel

II - LOCATION OF COMPONENTS

Telephone aerial

To remove the telephone aerial (see 86A, Radio, Radio aerial: Removal - Refitting, 86A-11).

Computer

"Hands-free" microphone

Telephone control at steering wheel

To remove the steering wheel car phone control (see 86A, Radio, Radio control satellite: Removal - Refitting, 86A-19).

Computer: Removal - Refitting

CAR PHONE PRE-EQUIPMENT or HANDS-FREE TELEPHONE KIT

Note: The computer is fitted behind the dashboard centre front panel under the radio.

REMOVAL

REMOVAL PREPARATION OPERATION

• Disconnect the battery (see Battery: Removal - Refitting).
• Remove the dashboard centre front panel (see Centre front panel: Removal - Refitting)

• Remove the computer (1).

• Disconnect the computer connectors (2).

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Connect the computer connectors.
• Refit the computer.

II - FINAL OPERATION.

• Refit the dashboard centre front panel (see Centre front panel: Removal - Refitting)
• Connect the battery (see Battery: Removal - Refitting).
• If replacing the computer, carry out the necessary operations using the Diagnostic tool (see Fault finding - Replacement of components) (86B, Car phone).

"Hands-free" microphone: Removal - Refitting

CAR PHONE PRE-EQUIPMENT or HANDS-FREE TELEPHONE KIT

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1).
• Remove the computer (see 86B, Car phone, Computer: Removal - Refitting, 86B-3).

• Unclip the dashboard side panel on the passenger side.
• Unclip the A-pillar trim on the passenger side (see Windscreen pillar trim: Removal - Refitting).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Remove the "hands-free" microphone wire from the A-pillar clips (1).

• Remove the "hands-free" microphone wire (2) from the dashboard side panel.

• Remove the "hands-free" microphone (3) from the headlining.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit the "hands-free" microphone with its wire as shown in the diagram above.
• Connect the "hands-free" microphone connector to the computer.

II - FINAL OPERATION.

• Clip:
  • the A-pillar trim (see Windscreen pillar trim: Removal - Refitting),
  • the dashboard side panel.
• Refit the computer (see 86B, Car phone, Computer: Removal - Refitting, 86B-3).
• Connect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1).

READ NEXT: