Renault Clio: Input shaft lip seal: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Transmission / Manual Gearbox / Input shaft lip seal: Removal - Refitting
JH3 or JR5
- Replace the lip seal after opening the gearbox (see Technical Note 3661A, gearbox JH - JR).
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the gearbox (see 21A, Manual gearbox, Manual gearbox: Removal - Refitting, 21A-12),
- the clutch thrust bearing (see 20A, Clutch, Clutch thrust bearing: Removal - Refitting, 20A- 11).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Drill a hole in the seal, using a 2.5 mm drill bit.
WARNING
Do not scratch the shaft or mating face.
- Fit a bolt in seal (1).
- Extract the seal (1) using pliers.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Fit a new seal with its protector using the (Bvi.1601).
- Remove the protector.
II - FINAL OPERATION
- Refit:
- the clutch thrust bearing (see 20A, Clutch, Clutch thrust bearing: Removal - Refitting, 20A- 11).
- the gearbox (see 21A, Manual gearbox, Manual gearbox: Removal - Refitting, 21A-12).
READ NEXT:
Differential output seal: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Batter
Reverse gear switch: Removal - Refitting
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the battery (see Battery: Removal - Refitting)
(80A, Battery),
the battery tray (see Battery tray: Removal - Refitting)
(80A, Battery).
SEE MORE:
Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note:
Ready-to-use coolant or antifreeze must be diluted
with distilled water in accordance with the guidelines
marked on the container.
Engine cooling: Precautions for the repair
IMPORTANT
The circuits are designed to be pressurized, so be
careful at high temp
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not open the expansion bottle cap,
do not drain the cooling system,
do not open the bleed screw(s).
N
© 2016-2026 Copyright Renault Clio Owners Club - 0.0055
