Renault Clio: Wheel trims - wheel
Renault Clio IV (2014-2019) Owners Manual / Practical advice / Wheel trims - wheel
Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2.
To refit it, align it with valve 2. Push the retaining hooks in fully, starting with side A near the valve, followed by B and C, finishing at D opposite the valve.
| Do not leave the tools unsecured inside the vehicle as they may come loose under braking. After use, check that all the tools are correctly clipped into the tool kit, then position it correctly in its housing: risk of injury. |
READ NEXT:
Changing a wheel
Switch on the hazard warning
lights.
Keep the vehicle away from
traffic and on a level surface
where it will not slip.
Apply the parking brake and engage
a gear (first or
Tyres (tyre and wheel safety, use in winter)
Tyre and wheel safety
The tyres are the only contact between
the vehicle and the road, so it is essential
to keep them in good condition. You
must comply with the local rules given
in the highway
Headlights (changing bulbs)
Direction indicator lights
Turn the bulb holder 1 a quarter of a
turn and take out the bulb.
Bulb type: PY24.
Once the bulb has been replaced,
check that it is properly secured.
T
SEE MORE:
Rear fog lights: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1
Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2
Move the rear fog light using the tool (Car. 1363) as a lever at (2).
Disconnect the rea
Interior Lighting
Interior lighting: Function
I - GENERAL INFORMATION
Vehicles may be fitted with the following units for lighting
the interior of the passenger compartment, depending
on the level of equipment:
a courtesy light (front central zone),
a courtesy light (rear central zone),
courtesy mirror lights (dr
© 2016-2026 Copyright Renault Clio Owners Club - 0.0035
