Renault Clio: Wheel trims - wheel
Renault Clio IV (2014-2019) Owners Manual / Practical advice / Wheel trims - wheel
Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2.
To refit it, align it with valve 2. Push the retaining hooks in fully, starting with side A near the valve, followed by B and C, finishing at D opposite the valve.
| Do not leave the tools unsecured inside the vehicle as they may come loose under braking. After use, check that all the tools are correctly clipped into the tool kit, then position it correctly in its housing: risk of injury. |
READ NEXT:
Changing a wheel
Switch on the hazard warning
lights.
Keep the vehicle away from
traffic and on a level surface
where it will not slip.
Apply the parking brake and engage
a gear (first or
Tyres (tyre and wheel safety, use in winter)
Tyre and wheel safety
The tyres are the only contact between
the vehicle and the road, so it is essential
to keep them in good condition. You
must comply with the local rules given
in the highway
Headlights (changing bulbs)
Direction indicator lights
Turn the bulb holder 1 a quarter of a
turn and take out the bulb.
Bulb type: PY24.
Once the bulb has been replaced,
check that it is properly secured.
T
SEE MORE:
Passenger Compartment Connection Unit
UCH: Removal - Refitting
RIGHT-HAND DRIVE
REMOVAL
I - REMOVAL PREPARATION OPERATION
If replacing the UCH, carry out the necessary programming
using the Diagnostic tool. (see Fault
finding - Replacement of components) (MR 394,
87B, Passenger compartment connection unit).
Disconnect the battery
Opening Element Management
Opening elements management: List and location of components
UCH
Renault card (simple or hands-free)
Key equipped with remote control
locking
Locking - unlocking motor
Specific reception receivers in
the handles and the rear
bumper
Proximity and movement sensor
Locking button on the handl
© 2016-2026 Copyright Renault Clio Owners Club - 0.0043
