Renault Clio: High pressure pipe: Check
K9K
WARNING
After any operation, check that there are no diesel fuel leaks
- Reprime the diesel circuit using the priming pump.
- Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
- Remove the engine protector.
- Disconnect the inlet air pressure sensor (1)
- Remove the upper section (2) of the turbocharging duct.
- Loosen the clip (3).
- Move the inlet duct to one side (4).
- Unclip the clips (5) from the injector rail protector cover.
- Remove the mounting (6) from the injector rail protector cover.
- Remove the injector rail protector cover (7).
- Refit the inlet duct.
- Loosen the mounting nut of the air pipe at the intercooler inlet on the alternator.
- Fit the air duct between the turbocharger and the intercooler air inlet pipe.
- Snap the air duct to the turbocharger and to the air pipe at the intercooler inlet.
- Tighten the bolt of the air duct on the rocker cover.
- Torque tighten the nut mounting the intercooler air inlet pipe on the alternator (8 Nm).
- Connect:
- the inlet air pressure sensor.
- the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
Note: The Diagnostic tool can be used for testing the high pressure circuit with the engine running.
This command can be used to run fault finding
on a leak due to an incorrectly fitted or tightened
union. This command only works if the engine
coolant temperature is above 60READ NEXT:
K9K, and 750 or 752 or 760 or 762 or 766 or 768
Note:
Vehicles equipped with the K9K*768 engine may or
may not be equipped with an intercooler.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the
Accelerometer: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Disconnect the battery (see Battery: Removal - Refi
Crankshaft position sensor: Removal - Refitting
SEE MORE:
Horn
Press steering wheel boss A.
Headlight flasher
Pull stalk 1 towards you to flash the
headlights.
Direction indicators
Move stalk 1 parallel to the steering
wheel and in the direction you are going
to turn it.
One-touch mode
When driving, it is possible that the
steering wheel may
Audible and visual signals
On vehicles fitted with this function,
control A allows you to adjust the height
of the beams according to the load.
Turn control A downwards to lower the
headlights and upwards to raise them.
If driving on the left in a left-hand
drive vehicle (or vice versa), drivers
must h
Headlight adjustment
