Renault Clio: Wheel trims - wheel
Renault Clio IV (2014-2019) Owners Manual / Practical advice / Wheel trims - wheel
Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2.
To refit it, align it with valve 2. Push the retaining hooks in fully, starting with side A near the valve, followed by B and C, finishing at D opposite the valve.
| Do not leave the tools unsecured inside the vehicle as they may come loose under braking. After use, check that all the tools are correctly clipped into the tool kit, then position it correctly in its housing: risk of injury. |
READ NEXT:
Changing a wheel
Switch on the hazard warning
lights.
Keep the vehicle away from
traffic and on a level surface
where it will not slip.
Apply the parking brake and engage
a gear (first or
Tyres (tyre and wheel safety, use in winter)
Tyre and wheel safety
The tyres are the only contact between
the vehicle and the road, so it is essential
to keep them in good condition. You
must comply with the local rules given
in the highway
Headlights (changing bulbs)
Direction indicator lights
Turn the bulb holder 1 a quarter of a
turn and take out the bulb.
Bulb type: PY24.
Once the bulb has been replaced,
check that it is properly secured.
T
SEE MORE:
Ashtray, cigarette lighter
Cigarette lighter 1
With the ignition on, push in the cigarette
lighter 1. It will spring back with a
click when it is ready. Pull it out to use.
After use, replace it without pushing it
all the way in.
Ashtray
It can be housed in either position 2
or 3.
If your vehicle is
Rear bench seat: functions
Position for use
Raise the headrest as far as possible to
use it in the high position. Check that it
is correctly locked.
Storage position
Press button A and lower the headrest
completely.
When the headrest is set at the
lowest position, this is for storage
only. It should not be in t
© 2016-2026 Copyright Renault Clio Owners Club - 0.0045
