Renault Clio: Wheel trims - wheel
Renault Clio IV (2014-2019) Owners Manual / Practical advice / Wheel trims - wheel
Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2.
To refit it, align it with valve 2. Push the retaining hooks in fully, starting with side A near the valve, followed by B and C, finishing at D opposite the valve.
| Do not leave the tools unsecured inside the vehicle as they may come loose under braking. After use, check that all the tools are correctly clipped into the tool kit, then position it correctly in its housing: risk of injury. |
READ NEXT:
Changing a wheel
Switch on the hazard warning
lights.
Keep the vehicle away from
traffic and on a level surface
where it will not slip.
Apply the parking brake and engage
a gear (first or
Tyres (tyre and wheel safety, use in winter)
Tyre and wheel safety
The tyres are the only contact between
the vehicle and the road, so it is essential
to keep them in good condition. You
must comply with the local rules given
in the highway
Headlights (changing bulbs)
Direction indicator lights
Turn the bulb holder 1 a quarter of a
turn and take out the bulb.
Bulb type: PY24.
Once the bulb has been replaced,
check that it is properly secured.
T
SEE MORE:
Front seat lower casing: Removal - Refitting
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 2
IMPORTANT
Before doing any work on a safety system component,
be sure to lock the airbag computer using the
Diagnostic tool (see Airbag and pretensioners:
Precautions for the repair). When this function is
activated, all the trigger lines are inhibited
Rear Seat Trim
1/3 and 2/3 rear bench seat base trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lift up the rear bench seat base.
Remove the rear bench seat base at (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the retaining strips (2).
Remove the seat trim and foam.
© 2016-2026 Copyright Renault Clio Owners Club - 0.0066
