Renault Clio: Expansion chamber: Removal - Refitting

Renault Clio. Expansion chamber: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Expansion chamber: Removal - Refitting

Note: If the rubber mounting bushes are damaged, mark the position of the support on the body, then replace the " support - rubber mounting bush " assembly.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION.

WARNING

Make sure:

READ NEXT:

 Intermediate pipe: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). II - OPERATION FOR REMOVAL OF PART CONCERNED

 Silencer: Removal - Refitting

D4F or K4J or K4M or K9K or M4R REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Cut the exhau

 Tank

SEE MORE:

 Front end lower cross member: General description

WARNING The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading this general information, check that there are no special notes associated with this vehicle. These special notes are specified if necessa

 Driver's front side door wiring: Removal - Refitting

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). REMOVAL I - REMOVAL PREPARATION OPERATION Raise the window fully. Switch off the ignition. Disconnect the battery

© 2016-2025 Copyright Renault Clio Owners Club