Renault Clio: Cabin filter: Removal - Refitting
LEFT-HAND DRIVE
Note:
The cabin filter is located in the passenger side A-pillar.
REMOVAL
I - REMOVAL PREPARATION OPERATION
SCHOOL VEHICLE
- Remove the clutch pedal (see Clutch pedal: Removal
- Refitting) (MR392, 37A, Mechanical component
controls).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the passenger compartment filter at (1).
- Remove the cabin filter.
Note:
Foreign bodies (leaves, insects etc.) are likely to
accumulate in the cabin filter. Remove the cabin
filter with care so as to prevent foreign bodies
getting into the evaporator.
REFITTING
I - REFITTING PREPARATION OPERATION
- Check for foreign bodies in the passenger compartment
filter housing, and clean thoroughly if necessary.
II - REFITTING OPERATION FOR PART
CONCERNED
- Engage the upper section of the base of the filter into
the distribution unit.
- Clip the lower section of the filter base onto the distribution
unit.
III - FINAL OPERATION
SCHOOL VEHICLE
- Refit the clutch pedal (see Clutch pedal: Removal -
Refitting) (MR 392, 37A, Mechanical component
controls).
RIGHT-HAND DRIVE
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the passenger compartment filter at (1).
Note:
Foreign bodies (leaves, insects etc.) are likely to
accumulate in the passenger compartment filter.
Remove the filter with care so as to prevent foreign
bodies getting into the evaporator.
- Remove the passenger compartment filter.
REFITTING
I - REFITTING PREPARATION OPERATION
- Check for foreign bodies in the cabin filter housing,
and clean thoroughly if necessary.
II - REFITTING OPERATION FOR PART
CONCERNED

READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 394, 88C, Airbags and pretensioners).
Disconnect
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove seal (1).
Remove the side panel (2).
Remove the bolt (3) from the base
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the glovebox (see Glovebox: Removal - Refitting)
(MR 393, 57A, Interior equipment),
SEE MORE:
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
WARNING
To prevent damage to the wiring harness when
refitting, observe the original routing.
REMOVAL
I - REMOVAL PR
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove the front engine cover.
K9K, and 772
Discharge the pressure in the fuel supply circuit of
the exhaust fuel injector (see 19B, Exhaust, Exhaust
© 2016-2025 Copyright Renault Clio Owners Club
