Renault Clio: Gear selection sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Transmission / Sequential Gearbox / Gear selection sensor: Removal - Refitting

K9K, and JA5

Renault Clio. Gear selection sensor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Gear selection sensor: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

D4F, and JA3

Renault Clio. Gear selection sensor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Gear selection sensor: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

READ NEXT:

 Clutch position sensor: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Batte

 Solenoid valve assembly pressure sensor: Removal - Refitting

K9K, and JA5 REMOVAL REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run co

 Sequential gearbox engine speed sensor: Removal - Refitting

D4F, and JA3 REMOVAL I - REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, ru

SEE MORE:

 Front side door protective strip: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Unclip the blanking cover (1). Remove the bolt. Remove the side mounted indicator (2) using a small flat screwdriver. Disconnect the power supply connector. II - REMOVAL OPERATION FOR PART CONCERNED Slide the door rubbing strip towards the rear

 Power Assisted Steering

Power-assisted steering: Function Assistance varies according to vehicle speed. IMPORTANT Do not remove any steering column component. Note: During fault finding, the Service warning light flashes at a frequency of 2 Hz. Power-assisted steering box: List and location of components Steering rack

© 2016-2025 Copyright Renault Clio Owners Club