Renault Clio: K4J

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Timing belt: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Timing belt: Removal - Refitting

Note: Do not drop the crankshaft timing sprocket when removing the timing belt.

REFITTING - PROCEDURE 1

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

1 - Adjusting the timing

WARNING

Be sure to degrease:

This is to avoid timing slippage.

This slippage leads to engine damage.

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

2 - Refitting

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

READ NEXT:

 F4R

WARNING Do not run the engine without the accessories belt to avoid damaging the crankshaft accessories pulley. Note: Two different engine support tools can be used to remove the right-hand suspe

 K9K, and 750 or 752

IMPORTANT Wear protective gloves during the operation. WARNING Never rotate the engine anti-clockwise (timing end). WARNING Do not run the engine without the accessories belt, to avoid breaking the c

 K9K, and 764 or 772

IMPORTANT Wear protective gloves during the operation. WARNING Never rotate the engine anti-clockwise (timing end). WARNING Do not run the engine without the accessories belt, to avoid breaking the c

SEE MORE:

 Headlining wiring: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Depending on the equipment level of the vehicle, remove the covers for the interior rear-view mirror in order to disconnect the rain sensor connector (see 85A, Wiping - Washing, Rain and light sensor: Removal - Refitting, 85A-5). Remove the headlining

 Electro-hydraulic unit: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: When replacing the electric pump assembly, always replace the control relay. IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run command " Disc

© 2016-2025 Copyright Renault Clio Owners Club