Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Top And Front Of Engine

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

SEE MORE:

 Rear brake calliper: Removal - Refitting

Note: The callipers supplied as replacement parts are pre-filled. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). WARNING Prepare for brake fluid outflow, to prevent damage to the mechanical parts and bodywork around the brak

 Oil-coolant heat exchanger: Removal - Refitting

K9K, and 764 or 766 or 768 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the engine protector, the front bumper (see Front bumper: Removal - Refitting) (55A, Exterior protection), the

© 2016-2025 Copyright Renault Clio Owners Club