Renault Clio: Top And Front Of Engine
- Pressure at end of compression: Check
- Accessories belt: Removal - Refitting
- Crankshaft accessories pulley: Removal - Refitting
- Timing belt: Removal - Refitting
- Timing chain: Removal - Refitting
- Rocker cover: Removal - Refitting
- Camshaft dephaser: Function
- Camshaft dephaser: Removal - Refitting
- Camshaft: Removal - Refitting
- Camshaft seal, timing end: Removal - Refitting
- Oil decanter: Removal - Refitting
- Lifting eyes: Removal - Refitting
- Cylinder head: Removal - Refitting
READ NEXT:
Pressure at end of
compression: Check
K9K
Remove the heater plugs (see 13C, Preheating,
Heater plugs: Removal - Refitting, 13C-2).
Disconnect:
the pressure regulation solenoid valve connector (1),
the flow control solenoid val
Accessories belt: Removal -
Refitting
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Crankshaft accessories
pulley: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the fron
SEE MORE:
Electro-hydraulic unit: Removal - Refitting
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Note:
When replacing the electric pump assembly,
always replace the control relay.
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Disc
Front end lower cross member: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
there are no special notes associated with this vehicle.
These special notes are specified if necessa
© 2016-2025 Copyright Renault Clio Owners Club
