Renault Clio: Flywheel: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine And Cylinder Block Assembly / Flywheel: Removal - Refitting

D4F or F4R or K4J or K4M or K9K

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).
• Disconnect the battery (see ) (80A, Battery).
• Remove:
  • the gearbox (see Manual gearbox: Removal - Refitting) (21A, Manual gearbox),
  • the clutch pressure plate (see Pressure plate - Disc: Removal - Refitting) (20A, Clutch).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Lock the flywheel using tool (Mot. 582-01) (1).
• Remove:
  • the flywheel bolts,
  • the flywheel,
  • the (Mot. 582-01) (1).

REFITTING

I - REFITTING PREPARATION OPERATION

• parts always to be replaced: Flywheel bolts.
• Use SURFACE CLEANER (see ) (04B, Consumables - Products) to clean and degrease:
• the flywheel bearing face if reusing,
• the crankshaft bearing face.

II - REFITTING OPERATION FOR PART CONCERNED

• Refit the flywheel.

K9K, and TL4

WARNING

Do not remove the flywheel drive plate mounting bolts (2).

K9K, and JA5 or JH3 or JR5

• Refit the spacer (3) observing the fitting direction of the chamfer on the flywheel end.

• Observe the tightening order.

K4J or K4M

• Tighten in order and to torque the flywheel bolts (K4) (25 N.m + 50

READ NEXT: