Renault Clio: Rear loading trim: Removal - Refitting
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION

- Remove:
- the rear parcel shelf,
- the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Unclip the clips (2).
- Remove the rear end panel central trim assembly.

- Unclip the clips (3).
- Remove the emergency spare wheel flap (4).

- Remove:
- the bolts (5),
- the retaining hooks.


- Remove:
- the bolts (7),
- the centre rear parcel shelf supports.


- Gently lift the luggage compartment tray (9).


- Detach the rear side sections (11) of the luggage
compartment.
- Remove the luggage compartment tray through the
tailgate by bending it slightly (this operation requires
two people).

- Remove the soundproofing.

- Remove the luggage compartment tray mounting (12).

- Remove:
- the bolt (13),
- the load stop bracket.


- Remove the load stop floor by unclipping it towards
the rear (15) (this operation requires two people).
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the load stop floor (this operation requires two people),
- the bolts (14),
- the load stop bracket,
- the bolt (13),
- the luggage compartment tray mounting (12),
- the soundproofing,
- the luggage compartment tray (this operation requires
two people),
- the trim (10),
- the bolts (8).
- Attach the rear side sections (11) of the luggage
compartment tray.
- Refit:
- the centre rear parcel shelf supports,
- the bolts (7) and (6),
- the retaining hooks,
- the bolts (5),
- the emergency spare wheel flap (4).
- Attach the clips (3).
- Refit the rear end panel central trim assembly.
- Attach the clips (2).
II - FINAL OPERATION.
- Refit:
- the centre rear parcel shelf, (1)
- the rear parcel shelf.
READ NEXT:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front speaker (see Front speakers:
Removal - Refitting) (MR 392, 86A, Radio).
Unclip the door mirror trim piece (1).
II - OPERATION FOR REM
B85 or K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Special features of vehicles fitted with manual
window winders
Unclip the winder handle (1) using a pair of unclipping
pliers (protect the door
SEE MORE:
LEFT-HAND DRIVE
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
WARNING
To prevent damage to the wiring harness when
refitting, observe the original routing.
Note:
K9K, and 750 or 752 or 766 or 768
Operating diagram of the diesel fuel supply circuit
The circuit comprises:
a sender (1),
a priming bulb (2),
a fuel filter (3) that can be fitted with a water detection
sensor,
a high pressure pump (4) with a built-in mechanical
low pressure pump (transfer p
© 2016-2025 Copyright Renault Clio Owners Club
