Renault Clio: Front end lower cross member: General description
Renault Clio III (2005-2013) Service Manual / Panelwork / Front Lower Structure / Front end lower cross member: General description
WARNING
The information contained in the following describes the general repair procedure for all vehicles having the same design for this part.
Before reading this general information, check that there are no special notes associated with this vehicle.
These special notes are specified if necessary in other parts of the sub-section dealing with the component.
Note: For a detailed description of a particular connection, see MR 400, 40A, General Information.
DESIGN OF THE STRUCTURAL COMPONENT
A special feature of this part is that it is bolted to the ends of the front side members via the radiator cross member mounting support.
Front impact cross member: Removal - Refitting
I - REMOVAL
1 - REMOVAL PREPARATION OPERATION
- Remove the front bumper (see Front bumper: Removal - Refitting).
- Remove the headlights (see ) (see Xenon headlight: Removal - Refitting).
2 - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove side mounting bolts (1) (three on either side).
II - REFITTING
1 - REFITTING OPERATION FOR PART CONCERNED
- Refit the side mounting bolts.
WARNING
The cross member contributes to the structural rigidity of the engine compartment. For this reason, the tightening torque must be observed following any operation.
- Torque tighten the side mounting bolts (1) (44 Nm).
2 - FINAL OPERATION
- Refit the headlights (see ) (see Xenon headlight: Removal - Refitting).
- Refit the front bumper (see Front bumper: Removal - Refitting).
READ NEXT:
Radiator mounting cross member: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
ther
Front side member: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
Front side member, centre section: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
SEE MORE:
Specialised bodywork tools: Use
USING THE DASHBOARD CROSS MEMBER
REMOVAL TOOL Car. 1765
Use this tool as indicated in the dashboard removal
procedure.
Fit the tool Car. 1765 as far as the stop (10).
Screw the rod (11) onto the body (10) as far as the
stop.
Firmly lock tool body in the same way as a lock nut
against th
Reverse gear switch: Removal - Refitting
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the battery (see Battery: Removal - Refitting)
(80A, Battery),
the battery tray (see Battery tray: Removal - Refitting)
(80A, Battery).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Disconnect the connector (1) from the reverse
