DP0
The automatic transmission series number can be found in two places: on a label on the hydraulic distributor cover (1) and etched onto the outer casing (2) on the wheel side.
Automatic gearbox oil: Draining - Filling
DP0
I - OIL SERVICE
Note:
Drain the automatic transmission oil when the oil
is warm (60READ NEXT:
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray,
the fr
Automatic gearbox: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the gearbox (see 23A, Automatic gearbox,
Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Drive plate: Removal - Refitting
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Shift the selector lever to Neutral.
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove
the battery tray (se
Multifunction switch: Removal - Refitting
SEE MORE:
K9K, and 750 or 752 or 766 or 768
IMPORTANT
Before carrying out any work on the injection system,
check using the Diagnostic tool :
that the injector rail is not under pressure,
that the fuel temperature is not too high.
It is essential to respect the safety and cleanliness
advice whenever work
Flow actuator: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the top of the pillar trim at (2).
remove the pillar trim by pulling upwards.
REFITTING
I - REFITTING PREPARATIONS OPERATION
Check the condition of the clips (3
Windscreen pillar trim: Removal - Refitting