Renault Clio: Gear selection sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Transmission / Sequential Gearbox / Gear selection sensor: Removal - Refitting

K9K, and JA5

Renault Clio. Gear selection sensor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Gear selection sensor: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

D4F, and JA3

Renault Clio. Gear selection sensor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Gear selection sensor: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

READ NEXT:

 Clutch position sensor: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Batte

 Solenoid valve assembly pressure sensor: Removal - Refitting

K9K, and JA5 REMOVAL REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run co

 Sequential gearbox engine speed sensor: Removal - Refitting

D4F, and JA3 REMOVAL I - REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, ru

SEE MORE:

 Air mixing cable: Removal - Refitting

LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove seal (1). Remove the side panel (2). Remove the bolt (3) from the base of the dashboard. Unclip the trim piece (4) from the driver's side dashboard lower cover. Remo

 M4R, and DP0

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). IMPORTANT During this operation, secure the vehicle to the lift with a strap to prevent it from becoming unbalanced. Remove the engine cover.

© 2016-2025 Copyright Renault Clio Owners Club