Renault Clio: B-pillar trim: Removal - Refitting
B85

REMOVAL
I - REMOVAL PREPARATION OPERATION

- Move the seats fully forward.
- Partially remove the frame seals (1).
- Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCERNED

- Unclip the B-pillar lower trim at (2).

- Remove the B-pillar lower trim.

- Unclip bolt cover.
- Remove the bolt (3).

- Use a flat-blade screwdriver to unclip the height adjustment control
(4).

- Unclip (5) the B-pillar upper trim (6).

REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Reclip:
- the B-pillar upper trim,
- the height adjustment device.
- Torque tighten the seat belt bolt (21 Nm).
- Reattach the B-pillar lower trim.
II - FINAL OPERATION.
- Refit the front and rear door sill trims.
- Refit the frame seals.
READ NEXT:
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
C85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32),
the rear roof drip moulding lini
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see Airbag and pretensioners: Precautions
for the repair) (88C, Airbags and pretensio
SEE MORE:
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any repair (see Front axle components:
Precautions for the repair).
WARNING
Prepare for the flow of fluid, and protect the surrounding
components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Posi
Topping up/filling
The vehicle must be parked on level
ground and the engine should be cold
(for instance, before the engine is started
up for the first time in the day).
Before performing any
action in the engine compartment,
the ignition must
be switched off by pressing
© 2016-2025 Copyright Renault Clio Owners Club
