Renault Clio: Rear fog lights: Removal - Refitting

REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1

- Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- Move the rear fog light using the tool (Car. 1363) as a lever at (2).
- Disconnect the rear fog light connector.
- Remove the rear fog light.
REFITTING
I - REFITTING PREPARATION OPERATION
K85, and DOCUMENTATION PHASE 1

- If the indicator light bulb needs replacing, remove:
- the bulb holder (3) by turning it forty-five degrees
counter-clockwise,
- the bulb from the bulb holder.
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- If the indicator light bulb needs replacing, remove:
- the bulb holder (4) by turning it forty-five degrees
counter-clockwise,
- the bulb from the bulb holder.
- When replacing a bulb, use an approved bulb.
II - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the bulb on the bulb holder,
- the bulb holder by turning it forty-five degrees
clockwise.
- Connect the rear fog light connector.
- Clip the fog light onto the rear bumper.
Number plate light: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the licence plate light using a flat-blade
screwdriver.
- Disconnect the connector.

- Unclip the light at (1) to gain access to the bulb.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- When replacing a bulb, use an approved bulb.

- Connect the connector.
- Refit the light.
READ NEXT:
Interior lighting: Function
I - GENERAL INFORMATION
Vehicles may be fitted with the following units for lighting
the interior of the passenger compartment, depending
on the level of equipment:
a cou
Fuses: List and location of components
Passenger compartment fuse and
relay box
Consumer cut-out fuse
Additional relay/fuse box
Battery protection fuses
Protection and switching unit
Power sup
SEE MORE:
I - LOCATION OF CONNECTORS
R 319 connecter (rear bumper/rear connection).
II - ACCESS TO CONNECTORS
IMPORTANT
Consult the safety and cleanliness advice and
operation recommendations before carrying out
any repair (see 88A, Wiring harness, Wiring:
Precautions for the repair, 88A-5).
WARNING
To pr
D4F, and 740 or 742 or 764
WARNING
Do not use any product designed to improve the
electrical contact in the injection computer and oxygen
sensor connectors or on the bodies of the oxygen
sensors. Failure to respect this advice prevents
the oxygen sensor from operating correctly and
results in failu
© 2016-2025 Copyright Renault Clio Owners Club
