Renault Clio: Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Rigid brake pipe: Removal - Refitting

The pipes have a rigid section and a flexible section. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Fit the pedal press to the brake pedal to limit the outflow of brake fluid. Raise the li

 Front lap belt pretensioner: Removal - Refitting

B85 or K85 IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88C, Air bag and Pretensioners, Airbag and pretensioners: Precautions for the repair, 88C-6). REMOVAL I - REMOVAL PREPARATION OPERATION IMPORTANT It is essential to lock

© 2016-2025 Copyright Renault Clio Owners Club