Renault Clio: Engine cooling: Parts and consumables for the repair
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Cooling / Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note: Ready-to-use coolant or antifreeze must be diluted with distilled water in accordance with the guidelines marked on the container.
Engine cooling: Precautions for the repair
IMPORTANT
The circuits are designed to be pressurized, so be careful at high temperatures (risk of serious burns).
Never remove the cap from the expansion bottle while the engine is hot.
Take care when carrying out a repair under the bonnet, as the radiator fan(s) may start to operate without warning.
Do not open the bleed valve(s) while the engine is running.
Only use recommended coolants: GLACEOL RX (TYPE D).
WARNING
- The coolant helps to keep the engine running properly (heat exchange).
- The system does not operate using pure water.
WARNING
Take care not to damage the cooling unit fins (radiator, condenser, etc.) during handling. When carrying out a repair that requires a complete circuit drain, it is essential to flush the circuit with clean water, blow compressed air through the circuit to eliminate water, fill and drain the circuit and then " measure the effective protection " . The parameters to be observed are:
- protection down to - 25
READ NEXT:
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not
Engine cooling system: Operating diagram
D4F
D4F, and 740 or 742 or 764
Engine
Cooling radiator
heater matrix
Expansion bottle
Water pump
Thermostat
Bleed screws
5 mm restriction
10 mm restriction
Note:
The rating of the expansio
Cooling system: Draining - Refilling
IMPORTANT
The circuits are designed to be pressurised, so be
careful at high temperatures (risk of serious burns).
Do not remove the cap from the expansion bottle
while the engine is hot.
Take care
SEE MORE:
Driver's frontal airbag: Removal - Refitting
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88C, Air bag and Pretensioners, Airbag
and pretensioners: Precautions for the
repair, 88C-6).
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
It is essential to lock the airbag
Rear brake lining: Removal - Refitting
DRUM BRAKE
Replace all the brake pads on one axle at the same
time. Never mix brake pads of different brands or qualities.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Release the parking bra
