Renault Clio: Cooling
- Engine cooling: Parts and consumables for the repair
- Engine cooling system: Check
- Engine cooling system: Operating diagram
- Cooling system: Draining - Refilling
- Cooling radiator: Removal - Refitting
- Coolant pump: Removal - Refitting
- Thermostat: Removal - Refitting
- Water chamber: Removal - Refitting
- Coolant temperature sensor: Removal - Refitting
- Engine cooling fan assembly: Removal - Refitting
- Coolant pump inlet pipe: Removal - Refitting
- Expansion bottle: Removal - Refitting
READ NEXT:
Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note:
Ready-to-use coolant or antifreeze must be diluted
with distilled water in accordance with the guidelines
marked on the container.
Engine cooling: Precauti
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not
Engine cooling system: Operating diagram
D4F
D4F, and 740 or 742 or 764
Engine
Cooling radiator
heater matrix
Expansion bottle
Water pump
Thermostat
Bleed screws
5 mm restriction
10 mm restriction
Note:
The rating of the expansio
SEE MORE:
Parking sensor
Operating principle
Ultrasonic detectors, installed in the
rear bumper (depending on the vehicle),
measure the distance between the
vehicle and an obstacle whilst reversing.
This measurement is indicated by
beeps which become more frequent the
closer you come to the obstacle, until
they be
Alternator: Removal - Refitting
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove the air inlet duct.
Disconnect the battery (see Battery: Removal - Refitting).
Remove:
the front right-hand w
© 2016-2025 Copyright Renault Clio Owners Club
