Renault Clio: Windscreen pillar trim: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Trim And Upholstery / Body Internal Trim / Windscreen pillar trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the top of the pillar trim at (2).
- remove the pillar trim by pulling upwards.
REFITTING
I - REFITTING PREPARATIONS OPERATION
- Check the condition of the clips (3).
II - REFITTING OPERATION FOR PART CONCERNED
- Refit the trim starting from the bottom.
III - FINAL OPERATION.
- Refit the seal (4).
Side roof rail rear trim: Removal - Refitting
C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the rear roof drip moulding lining.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- Refit the rear roof drip moulding lining.
READ NEXT:
B-pillar upper trim: Removal - Refitting
C85
REMOVAL
REMOVAL PREPARATION OPERATION
Remove:
the complete rear bench seat,
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B-pillar trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Move the seats fully forward.
Partially remove the frame seals (1).
Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCE
Rear inner sill upper trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
SEE MORE:
Clutch thrust bearing: Removal - Refitting
The thrust bearing is connected to the clutch slave cylinder.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Drain the brake reservoir using a syringe to remove
the clutch thrust bearing and control.
Remove the gearbox (see 21A, Manual gearbox,
Manual gearbox: Removal - Refitting, 21A- 12).
II - R
Shock absorber: Removal - Refitting
WARNING
To prevent any damage, do not use the rear axle as
support for the lifting system.
WARNING
To prevent any suspension asymmetry, replace
both of the shock absorbers on the same axle.
WARNING
To prevent the components of the rear axle from
deteriorating (rubber bushes, brake hoses, etc.) do
n
© 2016-2025 Copyright Renault Clio Owners Club
