Renault Clio: Windscreen pillar trim: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Trim And Upholstery / Body Internal Trim / Windscreen pillar trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the top of the pillar trim at (2).
- remove the pillar trim by pulling upwards.
REFITTING
I - REFITTING PREPARATIONS OPERATION
- Check the condition of the clips (3).
II - REFITTING OPERATION FOR PART CONCERNED
- Refit the trim starting from the bottom.
III - FINAL OPERATION.
- Refit the seal (4).
Side roof rail rear trim: Removal - Refitting
C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the rear roof drip moulding lining.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- Refit the rear roof drip moulding lining.
READ NEXT:
B-pillar upper trim: Removal - Refitting
C85
REMOVAL
REMOVAL PREPARATION OPERATION
Remove:
the complete rear bench seat,
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B-pillar trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Move the seats fully forward.
Partially remove the frame seals (1).
Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCE
Rear inner sill upper trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
SEE MORE:
Hydraulic unit - underbody union brake pipe: Removal - Refitting
LEFT-HAND DRIVE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Drain the coolant circuit using refrigerant charging
station.
Fit a pedal press on the brake pedal.
Disconnect the battery (see Battery: Removal - Refitting).
K4J o
Front seat lower casing: Removal - Refitting
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 2
IMPORTANT
Before doing any work on a safety system component,
be sure to lock the airbag computer using the
Diagnostic tool (see Airbag and pretensioners:
Precautions for the repair). When this function is
activated, all the trigger lines are inhibited
© 2016-2025 Copyright Renault Clio Owners Club
