Renault Clio: Gear selection sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Transmission / Sequential Gearbox / Gear selection sensor: Removal - Refitting

K9K, and JA5

Renault Clio. Gear selection sensor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Gear selection sensor: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

D4F, and JA3

Renault Clio. Gear selection sensor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Gear selection sensor: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

READ NEXT:

 Clutch position sensor: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Batte

 Solenoid valve assembly pressure sensor: Removal - Refitting

K9K, and JA5 REMOVAL REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run co

 Sequential gearbox engine speed sensor: Removal - Refitting

D4F, and JA3 REMOVAL I - REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, ru

SEE MORE:

 Opening Element Management

Opening elements management: List and location of components UCH Renault card (simple or hands-free) Key equipped with remote control locking Locking - unlocking motor Specific reception receivers in the handles and the rear bumper Proximity and movement sensor Locking button on the handl

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid valve connector (2), Fit the hose end piece (Mot. 1592) in place of one of the removed plugs.

© 2016-2025 Copyright Renault Clio Owners Club