Renault Clio: Brake compensator: Check

WITHOUT ANTI-LOCK BRAKING SYSTEM

Renault Clio. Brake compensator

CHECK

I - CHECKING THE DIMENSION OF THE BRAKING COMPENSATOR ROD IN THE REBOUND POSITION (WHEELS SUSPENDED)

Renault Clio. Brake compensator

II - ADJUSTING THE ROD DIMENSION IN THE REBOUND POSITION (WHEELS SUSPENDED)

III - CHECKING THE OUTPUT PRESSURE

WARNING

Prepare for the flow of fluid, and protect the surrounding components.

1 - Checking the output pressure for an input pressure (PE) = 60 bar

2 - Checking the output pressure for an input pressure (PE) = 100 bar

3 - Checking the output pressure values

4 - Checking the output pressures by compressing the spring by 5 mm

5 - Checking value D'

Brake compensator: Adjustment

WITHOUT ANTI-LOCK BRAKING SYSTEM

Renault Clio. Brake compensator

ADJUSTMENT

Renault Clio. Brake compensator

Renault Clio. Brake compensator

Note: When adjusting the brake limiter, do not move the rod nut (3).

READ NEXT:

 Parking brake lever: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the centre console (see Centre console: Removal - Refitting) (M

 Clutch control: List and location of components

Slave cylinder supply pipe (engine compartment) Left-hand drive slave cylinder supply pipe (engine compartment) Master cylinder (engine compartment / passenger compartment connection) Brake pipe

 Clutch pedal switch: Removal - Refitting

JH3 or JR5 or TL4, and CRUISE CONTROL - JH3 or JR5 or TL4, and VEHICLE WITH CARD REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the driver side dashboard lower trim clips (1), the driver si

SEE MORE:

 Shock absorber: Removal - Refitting

WARNING To prevent any damage, do not use the rear axle as support for the lifting system. WARNING To prevent any suspension asymmetry, replace both of the shock absorbers on the same axle. WARNING To prevent the components of the rear axle from deteriorating (rubber bushes, brake hoses, etc.) do n

 Flow actuator: Removal - Refitting

K9K, and 750 or 752 or 766 or 768 IMPORTANT Before carrying out any work on the injection system, check using the Diagnostic tool : that the injector rail is not under pressure, that the fuel temperature is not too high. It is essential to respect the safety and cleanliness advice whenever work

© 2016-2025 Copyright Renault Clio Owners Club