Renault Clio: Clutch
- Clutch: Precautions for the repair
- Pressure plate - Disc: Removal - Refitting
- Clutch thrust bearing: Removal - Refitting
READ NEXT:
Clutch: Precautions for the repair
Before removing the clutch, check:
The direction of fitting for the clutch plate.
Before refitting the clutch, check:
The flywheel friction track (no scratches or blue
stains),
The crankshaft
Pressure plate - Disc: Removal - Refitting
D4F or K4J or K4M or K9K, and 750 or 752 or 760 or 762 or 766 or 768, and
JH3 or JR5
REMOVAL
Remove the gearbox (see 21A, Manual gearbox,
Manual gearbox: Removal - Refitting, 21A-
12).
Lock
Clutch thrust bearing: Removal - Refitting
The thrust bearing is connected to the clutch slave cylinder.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Drain the brake reservoir using a syringe to remove
the clutch thrust bearing and control.
SEE MORE:
Rear suspension spring: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 35A-1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unpick the wheel speed sensor wiring har
Top Of Body
Roof: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associated
with the vehicle. These spe
© 2016-2025 Copyright Renault Clio Owners Club
