Renault Clio: Clutch
- Clutch: Precautions for the repair
- Pressure plate - Disc: Removal - Refitting
- Clutch thrust bearing: Removal - Refitting
READ NEXT:
Clutch: Precautions for the repair
Before removing the clutch, check:
The direction of fitting for the clutch plate.
Before refitting the clutch, check:
The flywheel friction track (no scratches or blue
stains),
The crankshaft
Pressure plate - Disc: Removal - Refitting
D4F or K4J or K4M or K9K, and 750 or 752 or 760 or 762 or 766 or 768, and
JH3 or JR5
REMOVAL
Remove the gearbox (see 21A, Manual gearbox,
Manual gearbox: Removal - Refitting, 21A-
12).
Lock
Clutch thrust bearing: Removal - Refitting
The thrust bearing is connected to the clutch slave cylinder.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Drain the brake reservoir using a syringe to remove
the clutch thrust bearing and control.
SEE MORE:
Structural components to be positioned on the repair bench: Description
I - PARTS REQUIRING THE USE OF A BODY JIG
BENCH
Radiator cross member support
Centre floor front side cross member
Front side member closure panel
Front side member
Engine stand
Front half-unit
Front wheel arch
Engine tie-rod attachment
Inner rear wheel arch
Rear side member
Rear sectio
K9K, and Right-hand Drive
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the engine cover,
the engine undertray,
the scu
© 2016-2025 Copyright Renault Clio Owners Club
