Renault Clio: Anti-submarining airbag: Removal - Refitting

C85

Renault Clio. Anti-submarining airbag: Removal - Refitting

IMPORTANT

Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88C, Air bag and Pretensioners, Airbag and pretensioners: Precautions for the repair, 88C-6).

REMOVAL

I - REMOVAL PREPARATION OPERATION

IMPORTANT

It is essential to lock the airbag computer using the Diagnostic tool before starting the removal.

When this function is activated, all the trigger lines are inhibited and the airbag warning light on the instrument panel is continuously lit (with the ignition on).

IMPORTANT

Handling pyrotechnic systems (airbags or pretensioners) near to a source of heat or flame is not permitted: there is a risk of triggering the airbags or pretensioners.

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Anti-submarining airbag: Removal - Refitting

Renault Clio. Anti-submarining airbag: Removal - Refitting

REFITTING

I - REMOVAL PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

IMPORTANT

Check the airbag computer using the Diagnostic tool. Any failure to follow these instructions may lead to system malfunctions, or even result in the incorrect triggering of the airbags.

IMPORTANT

Do not reuse the pyrotechnic components. The pretensioners or airbags on a vehicle which is to be scrapped must be destroyed.

READ NEXT:

 Side impact sensor: Removal - Refitting

FRONT SIDE AIRBAG or FRONT SIDE + CURTAIN AIRBAG IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88C, Air bag and Pretensioners,

 Panelwork

 General Information

SEE MORE:

 Locking, unlocking the opening elements

Locking/Unlocking the doors from the outside This is done using the RENAULT Card; see the “RENAULT Card” information in Section 1. In certain cases, the RENAULT card may not work: if the RENAULT card battery is weak, flat, etc. if equipment operating on the same frequency as th

 Windscreen pillar trim: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove the seal (1). II - OPERATION FOR REMOVAL OF PART CONCERNED Unclip the top of the pillar trim at (2). remove the pillar trim by pulling upwards. REFITTING I - REFITTING PREPARATIONS OPERATION Check the condition of the clips (3

© 2016-2021 Copyright www.rclio.com