Renault Clio: Choosing a child seat mounting

Rear-facing child seats

Renault Clio. Rear-facing child seats


A baby’s head is, proportionally, heavier than that of an adult and its neck is very fragile. Transport the child in this position for as long as possible (until the age of 2 at the very least). It supports both the head and the neck.

Choose a bucket type seat for best side protection and change it as soon as the child’s head is higher than the shell.

Forward-facing child seats

Renault Clio. Forward-facing child seats


The child’s head and abdomen need to be protected as a priority. A forward-facing child seat which is firmly attached to the vehicle will reduce the risk of impact to the head. Ensure your child travels in a forward-facing seat with a harness for as long as their size permits.

Choose a bucket type seat for optimum side protection.

Booster cushions

Renault Clio. Booster cushions


From 15 kg or 4 years, the child can travel using a booster seat, which will enable the seat belt to be adapted to suit his/her size and shape. The booster seat cushion must be fitted with guides to position the seat belt on the child’s thighs rather than the stomach.

It is recommended that you use a seatback fitted with a belt strap guide which can be adjusted in terms of height to position the seat belt in the centre of the shoulder. It must never rest on the neck or on the arm.

Choose a bucket type seat for optimum side protection.

READ NEXT:

 Choosing a child/baby seat mounting

There are two ways of attaching child seats: via the seat belt or using the ISOFIX system. Attachment via the seat belt The seat belt must be adjusted to ensure that it is effective in the event

 Fitting a child seat, general information

Some seats are not suitable for fitting child seats. The diagram on the following page shows you how to attach a child seat. The types of child seat indicated may not be available. Before using

 Child seat: attachment by seat belt or by Isofix system

SEE MORE:

 Opening Element Sealing

Door sealing film: Removal - Refitting REMOVAL Note: The sealing film can only be used once; it is destroyed when it is removed. It is essential to replace the film with a new one each time it is removed. REMOVING THE SEALING FILM Remove the door trim( (see Front side door trim: Removal - Refitt

 Sequential gearbox gear lever: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). II - OPERATION FOR REMOVAL OF PART CONCERNED Remove the gear lever cover (1) using a screwdriver. Disconnect the gear lever lighting connector (2).

© 2016-2021 Copyright www.rclio.com